Concrete Work in Rancho Santa Margarita and Nearby Towns
We pour driveways, patios, pool decks and walkways for homeowners in Rancho Santa Margarita and the towns around it. Every job gets the same base prep and curing plan, plus a visit after the slab has cured to check the joints and show you how to care for it.
Towns we cover from Rancho Santa Margarita
- Rancho Santa Margarita
- Mission Viejo
- Lake Forest
- Coto de Caza
- Las Flores
- Laguna Niguel
- Aliso Viejo
- San Juan Capistrano
- Laguna Hills
- Ladera Ranch
- Laguna Woods
Not on the list? Call (949) 990-5653 and ask.
Towns We Serve
Most of our work is in Rancho Santa Margarita, Las Flores, Coto de Caza and Ladera Ranch. The drive is short, which makes it easy to come back and look over a slab once it has had time to cure. We also take projects in Mission Viejo, Lake Forest, Laguna Hills and Laguna Woods.
Toward the coast, we work in Aliso Viejo, Laguna Niguel and San Juan Capistrano. The scope is the same wherever you live: driveways, patios, stamped concrete, pool decks, backyards, side yards, RV parking pads, garage floors, courtyards, steps and walkways. If your town is not on this list, ask us by phone and we will tell you plainly whether it is in range.
What Shapes a Concrete Job Around Here
- 01
Clay soil and sloped lots
Much of South Orange County sits on clay-rich soil that swells when it gets wet and shrinks as it dries. That movement is what cracks a thin slab poured over a weak base. We dig out soft material, compact a layer of crushed aggregate base, and set rebar on chairs so the steel sits in the middle of the slab instead of on the dirt. On sloped lots we also set the pitch so runoff moves away from your home's foundation rather than pooling against it.
- 02
Dry heat, Santa Ana winds and winter rain
Hot, dry afternoons and Santa Ana winds pull water out of fresh concrete faster than the slab can gain strength, which leads to fine surface cracks. We start pours early in the morning and keep the surface damp or sealed with curing compound. Control joints are cut at a set spacing so any shrinkage crack lands in the joint. From roughly November through March we watch the forecast closely, since rain on a fresh finish ruins the surface.
- 03
Homes from the 1980s through the 2000s
A large share of homes in the area were built in that window, and many original driveways and patios are now worn, stained or heaved by tree roots. Replacing one means breaking out the old slab, hauling it off and rebuilding the base before new concrete goes down.
- 04
HOA approval and city permits
Many neighborhoods here have HOAs that review exterior changes, including stamped patterns, color and driveway width. Get that approval before we schedule the pour; we can describe the materials and layout so your application is complete. Work in the public right-of-way, such as a driveway approach or a city sidewalk, usually needs a permit from the city. We tell you which rules apply to your lot and pull the permit when one is required.
- 05
After the forms come off
Foot traffic is usually fine after a day or two, cars after about a week, and the slab keeps gaining strength for roughly a month. We check back after the cure, look over the joints and edges, and explain when and how to seal it.
Tell Us Where Your Project Is
Give us your town and a short description of the job. We will talk through the site, the soil and any HOA steps, then set a time to come look at your home in person.